ASK AN EXPERTDescription
- Generation 4 Magazine release for the Glock
- Constructed from Billet 6061 Aluminum and Mil Spec hard anodized Black
- Honeycomb non-slip face; for a more tactile engagement surface
- The contact point on the mag release face is ergonomically angled to the rear
- Takes minutes to install with the use of needle nose pliers and a long shaft, slim, flat head screwdriver
- Note: It is easiest to remove and replace the GLOCK Mag Catch Spring for the magazine release installation
- Black Finish
DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.
Warranty Information
| Firearm Fit | Glock 20, 21, 29, 30, 40, 41 |
| Caliber | 9mm/40S&W/357SIG |
| Weight, oz | 0.15 |
