Description
- Forward rake gives positive retention when using “C-clamp” (thumb over bore) method of handguard support
- Works as a rest for supported firing positions
- Slight angle without significant bulk adds just the right amount of relief to the wrist without substantially increasing the girth of the handguard
- Small profile is just enough to get repeatable hand position on weapon for-end
- Innovative patent pending attachment method allows for robust clamping and alignment with minimal hardware and slender accessory size
- Textured in front and back for positive engagement
- Made in the U.S.A. from high quality, impact resistant polymers
Warranty Information
Installation Instructions - Tools Needed: T15 Torx Driver (Not Supplied) |
- Insert tool (T15 Torx driver) into the screw from under the BCM Picatinny Handstop - Push the tool into the screw to extend the Picatinny anchor, making it protrude from the top - With the Picatinny anchor protruding, slide the BCM Handstop onto the Picatinny Rail in the desired location - Push the Handstop against the rail, engaging the Handstop’s recoil lug to the intersecting Picatinny rail groove - With the recoil lug engaged, tighten the screw to snug the anchor (approximately 40 inch-lbs. plus quarter turn,*DO NOT OVER-TIGHTEN*) - Ensure there is no "play" or forward/backward movement once tightened *Blue thread locker may be used on threaded fasteners |