- One Piece Picatinny Rail
- Domestic 6061 T6 Extruded Aluminum Construction
- Mounting Hardware Included
This EVOLUTION GUN WORKS Mount is specifically for the Winchester Model 70 pre-64 standard action and post-64 long action and has 20 MOA cant. The middle spread is the distance between the two middle holes, center to center, on your receiver. The middle spreads on the Winchester Model 70 picatinny rail mounts are as follows:
Winchester 70 Short Action: 3.259"
Winchester 70 Long Action: 3.805"
Winchester 70 WSM: 3.514"
Winchester 70 WSSM: 3.225"
This mount comes standard with a bevel on both sides making it ambidextrous.
We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. The one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.
After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
Installation: We recommend 20 inch lbs of torque and a drip of blue loctite.
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
|Rail Type||One Piece Picatinny|
|Action Length||Standard Action, Long Action|
|Firearm Model||Winchester 70 Pre 64' All Calibers
Winchester 70 Post 64' Long Action
Winchester Model 670
Sears Model 53
Ted Williams Model 53
|Minute Of Angle (MOA)||20 MOA|
|Machined From||Domestic 6061 T6 Extruded Aluminum|
|Finish||Matte Black Anodizing|
|Center Spread, in||3.805"|
|Overall Length, in||7.064"|
|Height, in||.4" (Top of Receiver to Top of Picatinny)|
|Quick Disconnect Ring Compatible||No|
|Torque Specs||20 in/lbs|
|Mounting Hardware||#6-48 X 1/4 Screws and T-10 Bit Included|