EVOLUTION GUN WORKS Shotgun Picatinny Rail Mount For Mossberg 500, 590, 835, 930, 935 (All Years) (45310)

Are you looking to install a picatinny rail on your Mossberg 500, Mossberg 590, Mossberg 835, Mossberg 930, or your Mossberg 935? The EVOLUTION GUN WORKS Shotgun Picatinny Rail Mount is easy to install. It only requires 4 screws and a T10 Torx bit, both of which are provided with the picatinny mount. They even send #8-40 and #6-48 screws, so no matter when your Mossberg shotgun was manufactured, this rail will fit. Just remove any plugs in the receiver that were installed from the factory, place the Evolution Gun Works mount on the receiver, use a dab of blue thread locker and install the screws. Make sure to torque them to 15 in/lbs.

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. The one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite.

We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards