Description
- 6061 T6 Extruded Aluminum
- Compatible with Picatinny or Weaver scope rings
- Mounting hardware included
- Matte Black Finish
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories.
The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average.
Also, in many cases, it will not obstruct usage of factory iron sights.
EGW's one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
Add EGW's Practical or HD Scope Rings to make it a complete overhaul!
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is sold separately).
The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average.
Also, in many cases, it will not obstruct usage of factory iron sights.
EGW's one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
Add EGW's Practical or HD Scope Rings to make it a complete overhaul!
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is sold separately).
Warranty Information
- This mount fits: Winchester 1300, Winchester SXP (Super X Pump), FN SLP (mount must be drilled for #8 screws). The Winchester SX4 and SX3 requires 8-36 x 3/8 screws which are not provided with this mount. EGW does not have these screws.
- Rail Type: One Piece Picatinny
- Machined from: Domestic 6061 T6 Extruded Aluminum
- Finish: Matte Black Anodizing
- Center Spread: 2.49"
- Overall Length: 6.276"
- Height: .4" (Top of Receiver to Top of Picatinny)
- Weight: 2 oz.
- Quick Disconnect Ring Compatible: No
- Ambidextrous: Yes
- Torque Specs: 20 in/lbs
- Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included
