Description
- One Piece Picatinny Rail
- Domestic 6061 T6 Extruded Aluminum Construction
- Matte Black Anodized Finish
- Hex head screws and wrench provided
Make sure you have a solid base for your scope to mount on with the EVOLUTION GUN WORKS Picatinny Rail Scope Mount. The Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. EGW's one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
EGW Tikka 695 mount is made specific to the gun. This model will only fit the right hand eject rifle. Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.EGW recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, EGW recommend zeroing at 200 yards.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc. For more information, go to www.P65Warnings.ca.gov.
Warranty Information
| Fits | Tikka 695 |
| Minute Of Angle (MOA) | 0 MOA |
| Center Spread, in | 4.035" |
| Overall Length, in | 7.458" |
| Quick Disconnect Ring Compatible | No |
