ASK AN EXPERTDescription
- 7075 Aluminum Construction
- Hardcoat Anodized Type III Finish
- (2) 6-32 Button Head Screws
- (2) 6-32 X 3/16 Set Screws
The EVOLUTION GUN WORKS Holosun K Series Mount is made of 7075 Aluminum and has Matte Black Hardcoat finish. The red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
Installation Instructions:
- Remove the rear sight
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
Videos
View AllClose
Warranty Information
| Fit | Ruger MK I (Ruger Mark I) Ruger MK II (Ruger Mark II) Ruger MK III (Ruger Mark III) Ruger MK IV (Ruger Mark IV) Ruger P85 Ruger P90-95 Ruger P97 Ruger 22/45 This mount does not fit: Ruger P89 |
| Material | 7075 Aluminum |
| Coating | Matte Black Hardcoat |
| Overall Length, in | 1.604" |
| Overall Width, in | .99" |
| Mounting Hardware | (2) 6-32 Button Head Screws, (2) 6-32 X 3/16 Set Screws |
| Red Dot Fitment | Vortex Defender Series Bushnell RXS-100 Crimson Trace CTS-1500 Holosun 407K* Holosun 407k-GR Holosun 507K* Holosun 507k-GR Holosun EPS-GR* Holosun EPS-RD* Holosun EPS-Carry-GR* Holosun EPS-Carry-RD* Jpoint Leupold Delta Point Pro Optima Redfield Accelerator Shield RMS Shield RMSc Shield SMS Sig Romeo Zero |
