Description
- Material: 7075 Aluminum
- Coating: Matte Black Hardcoat
- Overall Length: 1.780"
- Overall Width: 1.1"
- Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-48 X .313 Set Screw
- Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice
Simply remove the rear sight on your gun and replace it with the EVOLUTION GUN WORKS Trijicon RMR/SRO, Holosun 407c/507c Mount for Bomar to mount your Trijicon RMR red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included.
Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)l
- Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
2 Flat Head Cap Screws - Provided for Trijicon RMR
The screws that are included with this mount require a 5/64" allen wrench for installation.
This mount fits:
STI Edge (either this sight or LPA)
Les Baer 1911 (adjustable rear sights)
Colt Gold Cup Trophy with Bomar Rear Sight Cut
Colt Gold Cup National Match .45 ACP
Colt Gold Cup National Match 9mm
Springfield TRP Operator
Dan Wesson Bruin (may require fitting due to the Clark cut on the top of the slide)
