ASK AN EXPERTDescription
- Solid 6061 T6 Extruded Aluminum
- Matte Black
- 5.48" Mount
- Fits Remington XP/XR 100 Model 7 Short Action
The bolt pattern on this mount will fit the Remington XP/XR 100 and the Remington 7.
The 3 hole mount is made for older versions with 3 holes. The 4 hole mount is for the newer versions with 4 holes.
We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. These one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.
After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
Installation: We recommend 20 inch lbs of torque and a drip of blue loctite.
We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
Warranty Information
| Machined From | Domestic 6061 T6 Extruded Aluminum |
| Finish | Matte Black Anodizing |
| Center Spread, in | 3.351" |
| Overall Length, in | 5.488" |
| Height, in | .4" (Top of Receiver to Top of Picatinny) |
| Quick Disconnect Ring Compatible | No |
| Ambidextrous | Yes |
| Torque Specs | 20 in/lbs |
| Mounting Hardware | #6-48 X 1/4 Screws and T-10 Bit Included |
| Weight | 2 oz. |
