ASK AN EXPERTDescription
- Made for Marlin 1895, 336, 444, Camp Carbine 9mm, Camp Carbine .45
- Machined From Domestic 6061 T6 Extruded Aluminum
- Mounting Hardware: Hex Head Screws and Wrench Provided
- This base sits at approximately 0.4" high
- Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories
- The channel in the center reduces the overall mass of the mount
- Picatinny-style base that compatible with Picatinny or Weaver scope rings
- Matte Black Anodized Finish
EVOLUTION GUN WORKS MARLIN PICATINNY RAIL SCOPE MOUNT
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average.
Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike. This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
The mounts are machined in one of EGW’s USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability. The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards. For installation EGW recommends 20 inch lbs of torque and a drip of blue Loctite.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average.
Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike. This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
The mounts are machined in one of EGW’s USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability. The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards. For installation EGW recommends 20 inch lbs of torque and a drip of blue Loctite.
Warranty Information
| Center Spread, in | 2.75" |
| Overall Length, in | 5.094" |
| Forward Cant | 0 MOA |
